Symbol-technologies VC5090 Uživatelský manuál stáhnout pdf (Strana 27)

Installation 2 - 3

Installing the VC5090 in a Forklift

Follow the instructions below to properly install the VC5090 in a forklift.

•

Determine the best location for mounting the vehicle computer taking into consideration the driver’s field

of view and ease of accessing the vehicle computer.

•

Install the appropriate mounting hardware.The VC5090 ships with four cap screws (3/8” - 16 - 2”) for

securing the mounting bracket. If the supplied cap screws are not long enough, use 3/8” - 16 - X cap

screws where X represents the length in inches of the required cap screws.

•

Connect the vehicle computer to the vehicle’s wiring system.

Positioning the Vehicle Computer

•

Determine the best position for the vehicle computer and all the associated components. If a similar

vehicle computer was previously installed, check to see if the position it used is suitable for the VC5090.

•

Test the installation for at least 30 minutes before installing on another vehicle. Record all details:

• Check that the position of the vehicle computer does not obstruct vehicle controls.

Figure 2-2

View Obstruction

• Check that the vehicle computer does not obstruct the driver's view.

• Check the position of the vehicle computer for user comfort over long periods.

• Check positioning to avoid extreme wrist angles that may cause injury.

CAUTION A competent engineer must perform the installation in a vehicle. Improper installation can injure the

operator and damage your vehicle and/or the VC5090.

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 209 210

Žádné komentáře

Symbol-technologies VC5090 Uživatelský manuál Strana 27